New World Industries proudly manufactures
all our products in America

New World Industries Inc

Controllers

New World Industries has been designing and developing controls since 2001. Having an Engineering team that has quality and innovation as a top priority insures the highest value in all of NWI’s products.

Controller

6500DC Dual 12V Motor Wireless Controller

For use with 12 volt de voltage only

The 6500DC Dual DC Motor Controller that provides RPM control for up to 2 single DC motors A up to 60AMP (Larger motor or conveyor or auger motor) and up to 40 amps to Motor B (smaller motor or spinner motor) The RPM control is done by providing the user 2 separate outputs, (3 speeds per motor low medium and full power) for each motor. The 6500DC incorporates an automatic shutdown to protect the motor and electronics.

Automatic shut down if motor is locked up. Unit will shut down for approx.30-60 seconds before you can attempt a restart.

Automatic shut off if the current draws do not drop below the rated amps after 5 to 7 seconds. Once again, the receiver will shut down for 30 to 60 seconds. You will need to investigate the problem as if you continue to override the control you will cause permanent damage to the receiver, motor or wiring.

Controller

6000DC Single 12V Motor Wireless Controller

For use with 12 volt de voltage only

The 6000DC Dual DC Motor Controller that provides RPM control for up to 1 single, DC motor up to 60AMP (Larger motor or conveyor or auger motor) and an on off circuit for a vibrator or light. The RPM control is done by providing the user 5 speed motor control in 1/5 increments. The 6000DC incorporates an automatic shutdown to protect the motor and electronics.

• Automatic shut down if motor is locked up. Unit will shut down for approx.30-60 seconds before you can attempt a restart.

• Automatic shut off if the current draws do not drop below the rated amps after 5 to 7 seconds. Once again, the receiver will shut down for 30 to 60 seconds. You will need to investigate the problem as if you continue to override the control you will cause permanent damage to the receiver, motor or wiring.